Results 1 to 10 of 41

Thread: Causes and Solutions to PIP problems

Hybrid View

  1. #1
    1cc of Lean Gain in each bicep was the worst. Biceps were also virgins at the time hahahah. 2nd time around, almost no pip

  2. #2
    Cut your shots 50:50 with sterile filtered oil. If you want to use 50mg of Testosterone Propionate, and you have 100mg/mL Testosterone Propionate- pull 0.5mL of your test prop, and 0.5mL of sterile filtered oil to shoot 1mL of 50mg/mL Testosterone Propionate. This is the #1 best way.
    Dont bother with b-12, its water based- absorbed so quickly it will have little to no impact.


    I didnt know we could do this... Does the raw get suspended properly if we cut it with oil before injection...?

    With the pain test-prop gives, heck Id rather shoot 2 ml than deal with the pain that 1 ml shells out.

  3. #3
    I try to get deep in the muscle and sometimes I do run it under some warm water to increase it's viscosity some. I have some test that i crippling and i use to keep EQ on hand to cut it or something cause it was unbearable last time. My whole ass cheek was red and hot. I sucked big time. Never tried bayer schering Test E but heard it is top notch and their Primo as well.

  4. #4
    Quote Originally Posted by Kalika ke Akua View Post
    I try to get deep in the muscle and sometimes I do run it under some warm water to increase it's viscosity some. I have some test that i crippling and i use to keep EQ on hand to cut it or something cause it was unbearable last time. My whole ass cheek was red and hot. I sucked big time. Never tried bayer schering Test E but heard it is top notch and their Primo as well.
    That sounds like badly made test to be honest. I had some thick ugl stuff a while back that seemed to take ages to absorb and sometimes gave irritation. Suspect quality ... Plus it was under dosed too

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •