Diary of a beast
07-24-2015, 10:58 AM
Hi All,
Not sure if this topic was brought up over here I couldn't find a thread either.
Please could the experienced users provide an insight on how they go about loading 2 or more compounds into one syringe even a link to a detailed pre post would help.
This is how I did it on my first try :
Test E @ 300mg per ml & Mast E at 200mg per ml (All products used are from MTS)
*After completing my hygiene routine *
Step 1 – Pull back 1ml worth of air
Step 2 – inserted needle into vial and pushed in 1 mil of air into vial
Step 3 – inverted vial and pulled back 1 mil worth of Test E
After this I inverted the syringe and pull back another ml worth of air so now I have 2 ml out of which 1ml worth of test the other mill is air. I changed the needle and put on a fresh 21 for the next draw
Step 1 – inserted needle into vial and inverted the unit (vial and syringe)
Step 2 – while inverted I pushed the air back into the vial (no test was intentionally pushed into the Mast E vial)
Step 3 – pulled out a bit more than 1 ml of test E to get rid of bubbles
I now have 2 ml worth or products in my syringe, changed needles to 23s and pinned
Please correct or comment the above process/recommend a different method
this is my first time doing it so laugh if you must :D
Not sure if this topic was brought up over here I couldn't find a thread either.
Please could the experienced users provide an insight on how they go about loading 2 or more compounds into one syringe even a link to a detailed pre post would help.
This is how I did it on my first try :
Test E @ 300mg per ml & Mast E at 200mg per ml (All products used are from MTS)
*After completing my hygiene routine *
Step 1 – Pull back 1ml worth of air
Step 2 – inserted needle into vial and pushed in 1 mil of air into vial
Step 3 – inverted vial and pulled back 1 mil worth of Test E
After this I inverted the syringe and pull back another ml worth of air so now I have 2 ml out of which 1ml worth of test the other mill is air. I changed the needle and put on a fresh 21 for the next draw
Step 1 – inserted needle into vial and inverted the unit (vial and syringe)
Step 2 – while inverted I pushed the air back into the vial (no test was intentionally pushed into the Mast E vial)
Step 3 – pulled out a bit more than 1 ml of test E to get rid of bubbles
I now have 2 ml worth or products in my syringe, changed needles to 23s and pinned
Please correct or comment the above process/recommend a different method
this is my first time doing it so laugh if you must :D