Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 26

Thread: cycle advice PLS

  1. #11
    Quote Originally Posted by SMonMTS View Post
    250 test e for 8 weeks then new cycle
    Approved, used Lean Gain (test p, tren a ,mast p) in the past and it was great. Depends if you mind more frequent pinning.

  2. #12
    have been pinning eod with just the test prop, and although id rather not. if its gonna get me the results then i'l do it

    so would you recommend running 250 test e alongside the lean gain or for 8 weeks after the cysle? sorry for all the questions

  3. #13
    Quote Originally Posted by SMonMTS View Post
    250 test e for 8 weeks then new cycle
    Nah, get bloods done, if bloods out of line cruise on test and mast for 4 weeks, redo bloods, if ok then go on to next blast. If first set of bloods is OK then keep going! It's what I did lol

  4. #14
    thank you

    do you just go to the local GP for bloods?

  5. #15
    Quote Originally Posted by canners View Post
    thank you

    do you just go to the local GP for bloods?
    Very dependent on your GP, most don't know much about it. I managed to get liver and cholesterol done at the GP, my brother was lucky and had a good one who did full panel whenever he wanted.

    Might need to get private ones done.

  6. #16
    Had my confirmation email today saying i should have my gear..... Can't wait for the results with some real deal var

    I managed to get some 1ml needles with the barrels attached. Is there a better way to draw with these as I started drawing with one earlier and gave up and went back to my standard 2inch blue and greens

  7. #17
    Quote Originally Posted by canners View Post
    Had my confirmation email today saying i should have my gear..... Can't wait for the results with some real deal var

    I managed to get some 1ml needles with the barrels attached. Is there a better way to draw with these as I started drawing with one earlier and gave up and went back to my standard 2inch blue and greens
    What gauge is the needle, I sometimes use slin pin with 30 gauge to pin MTS. You need to warm it with a hair dryer for a minute or so to the oil becomes less viscous.

  8. #18
    Back load your slin pins. Draw gear with standard pin, remove plunger of slin pin, deposit oil into the open barrel, gently put plunger back in, invert pin and remove air. Keeps your needle fresh on the slin pin for easy pokes and saves the hassle of drawing with that tiny ass needle.

  9. #19
    Quote Originally Posted by Serotonin101 View Post
    Back load your slin pins. Draw gear with standard pin, remove plunger of slin pin, deposit oil into the open barrel, gently put plunger back in, invert pin and remove air. Keeps your needle fresh on the slin pin for easy pokes and saves the hassle of drawing with that tiny ass needle.
    perfect thank you

  10. #20
    Quote Originally Posted by Serotonin101 View Post
    Back load your slin pins. Draw gear with standard pin, remove plunger of slin pin, deposit oil into the open barrel, gently put plunger back in, invert pin and remove air. Keeps your needle fresh on the slin pin for easy pokes and saves the hassle of drawing with that tiny ass needle.
    like so

    https://www.youtube.com/watch?v=52kEHcp5PKA

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •