Hi All,


Not sure if this topic was brought up over here I couldn't find a thread either.

Please could the experienced users provide an insight on how they go about loading 2 or more compounds into one syringe even a link to a detailed pre post would help.

This is how I did it on my first try :

Test E @ 300mg per ml & Mast E at 200mg per ml (All products used are from MTS)

*After completing my hygiene routine *

Step 1 – Pull back 1ml worth of air

Step 2 – inserted needle into vial and pushed in 1 mil of air into vial

Step 3 – inverted vial and pulled back 1 mil worth of Test E

After this I inverted the syringe and pull back another ml worth of air so now I have 2 ml out of which 1ml worth of test the other mill is air. I changed the needle and put on a fresh 21 for the next draw

Step 1 – inserted needle into vial and inverted the unit (vial and syringe)

Step 2 – while inverted I pushed the air back into the vial (no test was intentionally pushed into the Mast E vial)

Step 3 – pulled out a bit more than 1 ml of test E to get rid of bubbles

I now have 2 ml worth or products in my syringe, changed needles to 23s and pinned



Please correct or comment the above process/recommend a different method

this is my first time doing it so laugh if you must