Causes and Solutions to PIP problems

tunechi wrote:Pinning it nice and slow is a v.good tip

Yep, just pinned 4.25ml last night super slow and no pip today. Might be a bit sore later I work a bit but I'll be fine that's for sure.

Serotonin101 wrote:Yep, just pinned 4.25ml last night super slow and no pip today. Might be a bit sore later I work a bit but I'll be fine that's for sure.

yes, going slow can help a lot. even when using a slin pin for my cruising trt dosage, i can give myself pip from .5cc from pushing it in too quickly.

Good post

Was actually really surprised that I got no PIP at all from your super tren. I get PIP from most UG labs out there and was really happy to find MTS doesn't give any.

Awesome stuff.

I'm pinning 5ml twice a week with about half the gear being mts. No pip. Honestly I think my glutes can take more but my thumb tires as is from pushing that much oil.

I had taken some extremely painful 200mg per ml fast acting test of one thailand brand.I found heating up the gear in the syringe in a hot water helps with reducing pain.I think it had a high amount of alcohol in it.I also used to take a hot water bath & use a heating pad at times.If its from an underground lab its bound to pain.Nowadays when i started using MTS gear no pip at all.Totally painless.i tried med mutation,shreaded,tren ace & a few other products.

Sunbed helps

20 years I have been injecting and half the lads complaining about PIP are using gear sitting in a cold room. Warm the vial in your hands for two minutes. Problem gone. The other half have too much BA in home brews. MTS gear does not have this issue.

i always warm up the vials in the back of my knees for abt 3-5mins before injecting

Ai use 4 different mts oil . No PIP at all.

very few of our oils give any PIP, what can help is not inject too many ml's at the same time, massage slightly after injection, inject slowly, warm the vials gently just before so it goes in smoother but in general very few to almost none experience PIP with out products. we are specifically making them as such to cause no issues of any kind

Have to agree with this

I only seem to get some pip when
I'm doing more than 2ml in one area


If I keep it at 2ml or under in one area
Its fine

technique .anything high in ethyl oleate,i get pip ,some 500plus blends .once the pinis loaded i run keetle fullof hot water over syring depends how thick the oil is

Classic works. Warm the oil, take your time, use the right needle length for the muscle. I have been doing this for 15 years and the PIP guys always turn out to be rushing the injection or using room temperature gear. No shortcuts in injection technique.

I'm currently using 1ml/EOD of Test Prop and I inject my quads. I heat the oil and inject slowly.

I've been experiencing bad pain in my left leg for over a week now (limping around). I thought I may have hit a nerve because I've never experienced PIP like this in the past.

But now my right leg is very painful also, it may be as I've tried an alternate area of the quad because it was getting very hard to push the oil in on my right leg. Could it be virgin muscle? I'm still injecting the upper outer but in a different part of it.

I haven't been able to train legs for almost 2 weeks now 😣😣😣

our test prop is virtually painless. i would say your injection spot is not optimal

the oil is super smooth and this is an indication that you are either tensing the leg, using wrong needle size and/or injecting in the wrong spot.

try doing shoulders or glutes and see if it helps. but in general our stuff is virtually PIP free, even the high mg/ml blends and let alone the test prop which goes in like hot butter

To summarise for new members: warm the vial for 30-60 seconds, inject slowly, use correct gauge needle for IM injection. PIP that lasts more than 3-4 days or comes with fever and swelling is not normal PIP. Contact support immediately if that happens.

Big n full I did 1.5 ml first time in quad. Absolute agony 24 hours later for a full week. Same day next week I decided to lower dose 1ml same quad (like a dickhead) 24hours later same again am in absolute pain it's like someone has beaten my leg semi unconscious and I am dragging it along with me. Is this because I can't handle the BnF blend. Because I've have test 400 no pip I've done sust. Tren ace all with no pip. Ps I'm still quite a novice with my steroid intellegience

Hi all

I was writing about it but maybe I will get better answer here. I'm injecting TEST E and first 2 vials was OK, bought it without discount, another a few vials I bought with discount (site deal)everyone has the same batch number, I have opened 2 of them to check if something will change but still I'm feeling big pain after 2 days from injection, I have no idea where is the problem I don't think that there is problem with concentration, for me this is faulty batch, shame that I don't have different one without discount to check it. Please maybe someone has similar experience and will share how to sort it out to not skip it.

Only time I've ever got pip is not sticking to the outer top quadrant of the glute. Safe as houses there

Honestly had incredible pip when starting my first cycle, unbearable pain for unto ten days in every spot I tried...4/5 weeks in though my body accepted the compounds an I have never had pip since (Multiple cycles). MTS is the holy grail of quality gear, man up and crack on, it'll get better